Nailing Into Concrete Floor

Remove the board and vacuum away any dust from each hole.

Nailing into concrete floor. The wood could be a 2 x 4 bottom plate for a wall or a simple 2 x 2 cleat for some utility shelving in your basement or garage. Extend the pilot holes into the concrete. Push a drive pin into the barrel of the powder activated tool.

How to nail a stud wall to a cement floor 1. Now you are all set to nail you next diy project. Vacuum out pilot holes.

Tip 4 shanks. Consult your building plans and snap a chalk line to outline the area for the stud wall with pair of lines parallel. High air pressured or electric nail guns will definitely get the job done.

Now bore a pilot. Instructions drill pilot holes in the board. These nails are driven through a board and into concrete underneath much like nailing a wood board to a wood floor.

Begin by drilling a pilot hole through the board at each location you are nailing. These nails are cheap hold well as long as they penetrate at least inch into the concrete and are extremely hard to pull out. Concrete nails are shaped like thick common nails.

Choose the proper nails for your job. There are different lengths of concrete nail shank and you should purchase the right type. Concrete nails can be regular 16d sinker nails you can use regular 16d sinker nails as concrete nails in an upcoming project where you need to attach a piece of treated lumber to a poured concrete slab or a wall.